繁中  |  English
產品
JS-03

JS-03



 Car Jumper cable functions

 

Our car jumper cable has eight protection mechanisms and two features

 

Protection mechanisms:

  1. 1.    Short circuit protection-Short circuits or direct contact of the battery terminals(black and red clamp/ negative and positive terminals) will not produce sparking or cause any damage to the power bank units.               
  2. 2.    Reverse terminal connection protection-If the terminals are connected in reverse, there will be no power output, hence not producing sparking, or damaging the power bank units. Meanwhile a beeping alert will go off indicating reverse terminal connection.
  3. 3.    Reverse charging protection-The imbedded 8 POWER-MOS-IC’s can endure up to 400A of jump start currents and reverse charging currents, which is higher than the usual 200A~300A endurance. And therefore the 8 POWER-MOS-IC’s provide ample protection to the power bank units.
  4. 4.    Low voltage protection-When the power banks have a voltage output lower than 11V, the SW will not respond at the push of the on/off button. This is to avoid any battery damage or burnout caused by low-voltage discharges.
  5. 5.    Malfunctioning alert -Shall a malfunction occur in any of the 8 POWER-MOS-IC’s, a beeping alert goes off, indicating a malfunction, as long as the product is connected to a power source or a car battery. If the aforementioned situation presents itself, refrain from using the product to avoid damaging the power bank units.
  6. 6.    Sparking prevention-No sparking would occur whatsoever when the cables are hooked to car batteries. This mechanism is to avoid any personnel injury and car fire.

7.Power bank output limit protection-Power output of the power banks are limited, and as a result ruling out the possibilities of power bank damage or burnout due to high voltage output currents.

  1. 8.    Power bank reverse terminal connection protection-When the power bank input is connected in reverse by accident, no power output will occur in order to protect the jumper cable and the power bank units.

 

 

Features:

 

1. Manual jump start mode -If the car battery is fully discharged or malfunctioning, simply press and hold the “manual SW” button for 3 seconds, and the red light turns on, indicating the action of a forced 10-second power output, which jump starts the vehicle. Power output stops automatically in 10 seconds.

2.Signal light jump start mode-After the cable connection, the signaling red light under “IN ACTION” turns on if the cables are connected correctly. The operator can then start the vehicle.